Related Experiment Video
Updated: Oct 6, 2025

Cutting Procedures, Tensile Testing, and Ageing of Flexible Unidirectional Composite Laminates
Published on: April 27, 2019
Experimental Investigation on the Structural Performance of Single Span Hollow Core Slab under Successive Impact
Kamal Amin Chebo1, Yehya Temsah1, Zaher Abou Saleh2
1Civil and Environmental Engineering, Beirut Arab University, Beirut 1001, Lebanon.
Abstract:
In Lebanon and many other countries where structures are vulnerable to impact loads caused by accidental rock falls due to landslides, specifically bridges with hollow core slab, it is mandatory to develop safe and efficient design procedures to design such types of structures to withstand extreme cases of loading. The structural response of concrete members subjected to low velocity high falling weight raised the interest of researchers in the previous years. The effect of impact due to landslide falling rocks on reinforced concrete (RC) slabs has been investigated by many researchers, while very few studied the effect of impact loading on pre-stressed structures, noting that a recent study was conducted at Beirut Arab University which compared the dynamic behavior of reinforced concrete and post-tensioned slabs under impact loading from a 605 kg impactor freely dropped from a height of 20 m. Hollow core slabs are widely used in bridges and precast structures. Thus, studying their behavior due to such hazards becomes inevitable. This study focuses on these types of slabs. For a better understanding of the behavior, a full scale experimental program consists of testing a single span hollow core slab. The specimen has 6000 mm × 1200 mm × 200 mm dimensions with a 100 mm cast in a place topping slab. Successive free fall drops cases from 14 m height will be investigated on the prescribed slab having a span of 6000 m. This series of impacts will be held by hitting the single span hollow core slab at three different locations: center, edge, and near the support. The data from the testing program were used to assess the structural response in terms of experimental observations, maximum impact and inertia forces, structural damage/failure: type and pattern, acceleration response, and structural design recommendations. This research showed that the hollow core slab has a different dynamic behavior compared to the post tensioned and reinforced concrete slabs mentioned in the literature review section.
More Related Videos
Related Concept Videos
Impact Loading on a Cantilever Beam
When an object is dropped onto the free end of a cantilever, its potential energy due to gravity is...
Impact Strength of Concrete
Behavior of Concrete Under Compressive Load
As the concrete specimen fractures under...
Internal Loadings in Structural Members: Problem Solving
To illustrate this, let's consider a beam OC of 5 kN, inclined at an angle of 53.13° with the horizontal and supported at both ends. Determine the internal...
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Deformation of a Beam under Transverse Loading
The insights from the bending moment diagram extend to...

