Verification of embedding conditions for FBG sensor into textile product for the development of wearable healthcare...

To develop wearable healthcare sensors that use fiber Bragg grating (FBG) sensors, a stretch textile product with an embedded FBG sensor is required.

The FBG sensor, which is an optical fiber, was embedded into a textile product following a wavy pattern by using a warp knitting machine.

When an optical fiber is embedded in a textile product, the effect of the cycle length of wavy pattern and the number of cycles on the optical loss is verified. The shorter the cycle length of the wavy pattern of the optical fiber, and more increase in the number of cycles, the longer the textile product in which the optical fiber is embedded can expand and contract. However, when the cycle length of the wave pattern is 30 mm (shortest), large in optical loss, the pulse wave signal cannot be measured. If the cycle length of the wavy pattern is 50 mm or more, small in optical loss, the pulse wave signal is measured.

Compared with a straight pattern embedding FBG sensor, the amplitude value of the pulse wave signal measured with a cycle length of 50 mm is large, therefore the sensor sensitivity in this state is greater. This result is consistent with the measurement sensitivity depending on the angle of installation with respect to the direction of the artery.

With a cycle length of wavy pattern of 50 mm and 4 cycles, a stretch textile product with an embedded FBG sensor can be fabricated. Pulse wave signals are measured with this textile product, and the development of wearable healthcare sensors is expected.