CFD-PBM Simulation on Bubble Size Distribution in a Gas-Liquid-Solid Flow Three-Phase Flow Stirred Tank

The bubble size distribution, location distribution, and gas holdup in a gas-liquid-solid flow three-phase stirred tank were numerically simulated by the Eulerian-Eulerian method and the population balance model (PBM). The Euler-Euler method combined with the PBM model included the influence of bubble aggregation and fragmentation on the interfacial force, which can better predict the bubble size distribution and phase holdups. The simulation results show that there are some differences in the fluid morphology and gas dispersion characteristics in the stirred tank under different rotating speeds. With the increase of rotating speed, the content of small-diameter bubbles increases obviously, and they are mainly concentrated in areas with higher speeds. The higher the rotational speed, the more the bubbles with small diameters, but the content of bubbles with large diameters is less affected by the rotational speed. Small-size bubbles mainly exist in the region of high fluid velocity, while large-size bubbles mainly exist in the region of low hydrostatic pressure. Compared with the change of the bubble content at different speeds, the content of bubbles with diameters of 0.50-1.90 mm is largest at 2000 rpm, while the content of bubbles with diameters of 2.65-10.09 mm is largest at 1500 rpm. The simulation work has certain guiding significance for the research and development of the forced mineralization device and the understanding of the dispersion characteristics of bubbles in the stirred tank.