Related Experiment Video
Updated: Oct 5, 2025
Author Spotlight: Integrating Mechanical and Biological Analysis in Tendinopathy Research
Published on: March 1, 2024
Biomechanical Comparison of First Tarsometatarsal Arthrodesis Constructs Over Prolonged Cyclic Testing
Cynthia Prieto-Diaz1, Mathew R Anderle2, Laura Zagrocki Brinker2
1Medical Device Development, San Francisco, CA, USA.
Background:
Traditionally, a lengthy period of nonweightbearing is required following arthrodesis of the first tarsometatarsal (TMT) joint in order to provide a stable healing environment for the bones. The goal of this research was to determine the resistance to plantar gapping of 2 locked intramedullary devices and a medial plate with crossing screw, all specifically designed for hallux valgus correction, and compare them to traditional 2-crossing screw fixation under a cyclic testing protocol. We hypothesized the locked intramedullary devices and the medial plate with crossing screw would better resist plantar gapping.
Methods:
Forty cadaver specimens received 1 of 4 operative treatments: a locked intramedullary device with 2 points of fixation in the cuneiform, a locked intramedullary device with 1 point of fixation in the cuneiform, a medial plate with crossing screw, or 2 crossing screws. We applied dorsiflexion bending forces to the first TMT joint using a cadaveric fatigue model for 20 000 cycles. The plantar gap between the metatarsal and cuneiform was measured at the beginning and end of cyclic testing. Thirty-six specimens were included in the final data set.
Results:
Both locked intramedullary device groups and the medial plate with crossing screw group exhibited significantly less gap widening compared to the 2-crossing screw group (vs 3-hole intramedullary device, P = .014; vs 4-hole intramedullary device, P = .010; and vs medial plate with crossing screw, P = .044). The intramedullary device groups were the most stable during the cyclic fatigue test, exhibiting the smallest gap widening. The medial plate with crossing screw fixation was also more stable than crossing screws in the cyclic fatigue model.
Conclusions:
The locked intramedullary devices and medial plate with crossing screw resisted plantar gapping better than 2 crossing screws when used for first TMT arthrodesis.
Clinical Relevance:
These results indicate that locked intramedullary devices and medial plates with crossing screws may promote superior bone healing and may better tolerate early weightbearing compared with 2 crossing screws.
