One-way flow over uniformly heated U-shaped bodies driven by thermal edge effects

The thermal edge flow is a gas flow typically induced near a sharp edge (or a tip) of a uniformly heated (or cooled) flat plate. This flow has potential applicability as a nonmechanical pump or flow controller in microelectromechanical systems (MEMS). However, it has a shortcoming: the thermal edge flows from each edge cancel out, resulting in no net flow. In this study, to circumvent this difficulty, the use of a U-shaped body is proposed and is examined numerically. More specifically, a rarefied gas flow over an array of U-shaped bodies, periodically arranged in a straight channel, is investigated using the direct simulation Monte-Carlo (DSMC) method. The U-shaped bodies are kept at a uniform temperature different from that of the channel wall. Two types of U-shaped bodies are considered, namely, a square-U shape and a round-U shape. It is demonstrated that a steady one-way flow is induced in the channel for both types. The mass flow rate is obtained for a wide range of the Knudsen numbers, i.e., the ratio of the molecular mean free path to the characteristic size of the U-shape body. For the square-U type, the direction of the overall mass flow is in the same direction for the entire range of the Knudsen numbers investigated. For the round-U type, the direction of the total mass flux is reversed when the Knudsen number is moderate or larger. This reversal of the mass flow rate is attributed to a kind of thermal edge flow induced over the curved part of the round-U-shaped body, which overwhelms the thermal edge flow induced near the tip. The force acting on each of the bodies is also investigated.