Singlet oxygen generation in aerosol jet and on biological surfaces

The paper presents steady-state and time-resolved experiments on photophysical processes associated with photodynamic inactivation of infections provided by nebulization of Radachlorin photosensitizer solution. As models of surfaces subjected to photodynamic inactivation we used glass, plant leaf, mushroom cap peel and superficial fascia of chicken and salmon skin flaps. The oxygen content in the photosensitizer solution was varied by blowing with atmospheric air and with pure oxygen. It was shown that singlet oxygen was generated efficiently in the aerosol jet and that its amount increased noticeably at higher oxygen concentrations. The kinetics of photosensitizer photobleaching on different surfaces were found to be significantly different with characteristic decay times varying from seconds for leaf and glass to minutes for fascial flaps. This observation was attributed to much faster oxygen depletion on rough crumbly surfaces of biological samples due to effective oxidation reactions occurred. The singlet oxygen generation and degradation times, and the relative quantum yield were determined on different surfaces by recording time-resolved phosphorescence at about 1270 nm under normoxic and hyperoxic conditions and analyzed on the basis of the set of master equations. The results obtained provide reference marks for choosing optimal irradiation durations for photodynamic inactivation of pathogenic infectious agents (bacteria, mycobacteria, fungi, viruses) on mucous membranes, including the tracheobronchial tree.