Related Experiment Video
Updated: Oct 4, 2025

Vegetated Treatment Systems for Removing Contaminants Associated with Surface Water Toxicity in Agriculture and Urban Runoff
Published on: May 15, 2017
Stormwater management in urban areas using dry gallery infiltration systems
Miguel Ángel Marazuela1, Alejandro García-Gil2, Juan C Santamarta3
1Centre for Microbiology and Environmental Systems Science, Department of Environmental Geosciences, University of Vienna, Althanstrasse 14 UZAII, 1090 Vienna, Austria.
Abstract:
The increase in the frequency of extreme precipitation events due to climate change, together with the continuous development of cities and surface sealing that hinder water infiltration into the subsoil, is accelerating the search for new facilities to manage stormwater. The Canary Islands (Spain) are taking advantage of the knowledge acquired in the construction of water mines to exploit a novel stormwater management facility, which we have defined as a dry gallery. Dry galleries are constituted by a vertical well connected to a horizontal gallery dug into highly permeable volcanic layers of the vadose zone, from where infiltration takes place. However, the lack of scientific knowledge about these facilities prevents them from being properly dimensioned and managed. In this work, we simulate for the first time the infiltration process and the wetting front propagation from dry galleries based on a 3D unsaturated flow model and provide some recommendations for the installation and sizing of these facilities. The fastest advance of the wetting front takes place during the earliest times of infiltration (<2 h), with plausible propagation velocities and infiltration rates higher than 1000 m∙d-1 and 2 m3∙s-1. As time progresses, the propagation velocity and infiltration rate decrease as a consequence of the hydraulic gradient attenuation between the gallery and the aquifer. Therefore, stormwater infiltration is a highly transient process in which a sizing underestimation of 100% may be committed if unsaturated conditions or geological configuration are neglected.
Related Concept Videos
Conservation of Mass in Moving, Nondeforming Control Volume
In the context of a detention basin, the conservation of mass states that the total mass of water entering the basin must equal the mass leaving the basin plus any accumulation of...
Design Example: Design of an Irrigation Channel
Design Example: Analyzing Capacity Contours for Flood Risk Assessment
Cavity Drainage and Flashings in Masonry walls
Weep holes, strategically placed at the base of the cavity, are critical for draining accumulated water. These openings are created by leaving head...
Design Example: Designing a Residential Plumbing System
Design Example: Sustainability in Concrete Building
There are multiple approaches to achieve sustainability in a commercial concrete building. For instance, construct a concrete parking area under the building, utilizing pervious concrete paver blocks in open areas to facilitate rainwater collection through an underground...

