Optimization of a vehicle solution for the introduction and removal of glycerol with rabbit kidneys

Previous studies with rabbit kidneys in our laboratories have used a plasma-like solution as the vehicle for the introduction and removal of glycerol. Other workers have usually employed high-potassium solutions. In this study we have assayed the function of rabbit renal cortical slices after incubation in a range of solutions, each of which contained 1 M glycerol, for 4 hr, followed by stepwise removal of the cryoprotectant. The functions measured were endogenous oxygen consumption, p-aminohippurate uptake, and the ability of the slices to accumulate potassium. Exposure to glycerol produced a considerable reduction of slice function, but, in the presence of glycerol, elevation of the potassium concentration was beneficial, whereas high concentrations of magnesium were detrimental. The optimum potassium concentration was 70-100 mM. Replacement of chloride by a range of anions of higher molecular weight was either without benefit (glycerophosphate) or detrimental (sulfate, citrate, and gluconate). Elevation of total osmolality from 300 to 400 mosmolal with glucose, mannitol, glycerophosphate, or Pipes reduced slice function, but when the same osmolality was achieved by raising the concentration of all the components of the solution in the same ratio, there was no significant loss of function. There was a weak optimum pH at ca. 7.0. These experiments led to the formulation of a bicarbonate-buffered perfusate containing 80 mM potassium and 17.5 g Haemaccel per liter, having a pH of 7.0 with 5% CO2 at 10 degrees C, and an osmolality of 400 mosmol/kg. This solution was used to preserve rabbit kidneys for 20 hr at 10 degrees C, by continuous perfusion, and was compared with our previous Haemaccel perfusate, HP5, which contained 4 mM K+, 111 mM mannitol, and had a pH of 7.4. The two solutions were equally effective.