Influence of Friction Stir Process on the Physical, Microstructural, Corrosive, and Electrical Properties of an Al-Mg
Essam B Moustafa1, Mashhour A Alazwari1, Waheed Sami Abushanab2
1Mechanical Engineering Department, Faculty of Engineering, King Abdulaziz University, Jeddah 21589, Saudi Arabia.
Abstract:
In this study, two successive methods were used to improve the grain structure and the mechanical and physical properties of Al 5052 aluminum alloy. The modifying elements, 0.99 wt.% of titanium (Ti) and 0.2 wt.% of boron (B), were added during the casting process. After solidification, single- and double-pass friction stir processing (FSP) were performed to achieve additional grain refinement and disperse the newly formed phases well. The addition of Ti-B modifiers significantly improved the mechanical and physical properties of the Al 5052 aluminum alloy. Nevertheless, only a 3% improvement in microhardness was achieved. The ultimate strength (US), yield strength (YS), and elastic modulus were investigated. In addition, the electrical conductivity was reduced by 56% compared to the base alloys. The effects of grain refinement on thermal expansion and corrosion rate were studied; the modified alloy with Ti-B in the as-cast state showed lower dimension stability than the samples treated with the FSP method. The grain refinement significantly affected the corrosion resistance; for example, single and double FSP passes reduced the corrosion rate by 11.4 times and 19.2 times, respectively. The successive FSP passes, resulting in a non-porous structure, increased the bulk density and formed precipitates with high bulk density.
