Numerical Deformation Analysis of Reinforced Lightweight Aggregate Concrete Flexural Members

In the modern construction industry, lightweight aggregate concrete (LWAC) is often used to produce load-bearing structural members. LWAC can be up to 40% lighter by volume than normal strength concrete. However, the lack of adequate numerical models often limits the practical application of innovative building materials such as lightweight concrete in real projects. The present study conducted a comparative numerical deformation analysis of a full-scale bridge deck slab and girder. Using the physical model proposed by the authors and the finite element software ATENA, the deformations of full-scale lightweight and traditional reinforced concrete elements under the short-term effects of permanent and variable loads were compared. Depending on the safety and serviceability limit requirements, it was found that the amount of longitudinal reinforcement in lightweight reinforced concrete elements could be reduced compared with that in standard reinforced concrete elements with the same parameters. The results of the numerical analysis showed that the deformation analysis model proposed by the authors could serve as an alternative tool for the design of lightweight concrete flexural members with the selection of optimum geometric and reinforcement parameters limited by the stiffness condition.