Related Experiment Video
Updated: Oct 3, 2025

Guided Endodontics: Three-Dimensional Planning and Template-Aided Preparation of Endodontic Access Cavities
Published on: May 24, 2022
[Application of cold flowable gutta-percha in root canal obturation after apexification]
1First Clinical Division, Peking University School and Hospital of Stomatology & National Center of Stomatology & National Clinical Research Center for Oral Diseases & National Engineering Laboratory for Digital and Material Technology of Stomatology & Beijing Key Laboratory of Digital Stomatology, Beijing 100081, China.
Objective:
To evaluate the clinical effect of root canal obturation therapy using cold flowable gutta-percha on young permanent teeth after apexification.
Methods:
Ninety cases of young permanent teeth with pulp necrosis or periapical periodontitis treated by apexification were randomly divided into two groups. The cases in each group were divided into single root canal and multiple root canal according to the number of the root canal, and divided into classifications Ⅰ, and Ⅱ/Ⅲ/Ⅳ according to Frank's classification of root development after apexification. Cold flowable gutta-percha and warm gutta-percha obturation techniques were used for root canal obturation of the two groups. The operation time was recorded, and the patients' therapy pain degree was evaluated by visual analog scale (VAS) immediately after operation. Periapical X-ray was performed after operation to evaluate the effect of the root canal filling. The total length of the root was divided into equal three parts on the X-ray film, and three-dimensional tightness of the apical, middle, and coronal region of the root canals were statistically analyzed respectively. Clinical examinations and X-ray examination were performed 6 and 12 months after the operation to evaluate the treatment success rate.
Results:
The operation time of cold flowable gutta-percha group was significantly lower than that of the control group, which were 51 s and 74 s (P < 0.05); The percentages of pain and discomfort in the two groups were 26.67% and 40.00%, respectively. There were two cases of underfilling and no overfilling in both groups. The percentages of proper filling and tight three-dimensional obturation in the experimental and control groups were 71.11% and 60.00% respectively; and the percentages of tight three-dimensional obturation in the apical third areas were 86.67% and 66.67%, the difference was significant (P < 0.05). There was no significant difference in the three-dimensional tightness between the two groups in the middle and coronal third areas. The percentages of tight three-dimensional obturation in classification Ⅰ groups were 86.67%, 83.33%, 93.33% and 76.67%, 90.00%, 96.67% in experimental and control group, respectively; The percentages of classification Ⅱ/Ⅲ/Ⅳ groups were 86.67%, 86.67%, 100.00% and 46.67%, 86.67%, 100.00%, respectively, and the difference was significant (P < 0.05). There were no apical lesions that occurred in either group during the one-year review period.
Conclusion:
The application of cold flowable gutta-percha on young permanent teeth root canal obturation after apexification can achieve good obturation effect. The root obturation effect in the apical third area is significantly better than that of warm gutta-percha obturation techniques. Cold flowable gutta-percha can shorten the clinical treatment time and ameliorate the patients' therapy comfort.
More Related Videos
03:07Scanning Electron Microscopic Evaluation of Surface Defects of Remover Retreatment File After Single and Multiple Uses
Published on: October 11, 2024
07:03Dynamic Navigation in Endodontics: Guided Access Cavity Preparation by Means of a Miniaturized Navigation System
Published on: May 5, 2022
Related Concept Videos
Preplaced Aggregate Concrete
Porosity in Cement Paste
The balance of water to cement in the mix is...
Cavity Drainage and Flashings in Masonry walls
Weep holes, strategically placed at the base of the cavity, are critical for draining accumulated water. These openings are created by leaving head...
Accelerated Curing of Concrete
Flow Table Test
Concrete is placed within a truncated cone mold that is 8 inches high with an 8-inch base diameter and a 5-inch top diameter. The...