A custom interface for the joint operation of Med Associates and Tucker-Davis Technologies hardware in a rodent...

Rodent behavioral models with an electrophysiological component may require the joint operation of hardware from Med Associates, Inc. (St. Albans, VT) and Tucker-Davis Technologies (TDT; Alachua, FL). Although these manufacturers do produce supplemental hardware for interfacing with each other, investing in such hardware may be untenable for research groups with limited funds who wish to use equipment already in their possession.

We designed a printed circuit board (PCB) in KiCad and had it fabricated by Advanced Circuits (Aurora, CO), with components sourced from Digi-Key (Thief River Falls, MN). The PCB provided 8 channels of bidirectional communication for the transmission of signals between Med Associates' SG-716B SmartCtrl connection panel and TDT's RZ5D base station. This setup enabled the coordinated operation of programs running separately on each set of hardware.

The custom-built PCB facilitated the joint operation of Med Associates and TDT hardware in a go/no-go detection task involving rats with electrical implants in their sciatic nerves.

Conventional methods for interfacing Med Associates and Tucker-Davis Technologies rely on the purchase of pre-built hardware whose costs can add up to thousands of dollars. The present method offers a viable alternative that is easily implemented and considerably less expensive (below $200).

The present approach provides an inexpensive yet effective alternative to far more costly interfacing solutions offered by Med Associates and Tucker-Davis Technologies.