Related Experiment Video
Updated: Oct 3, 2025

Dissolved Solute Sampling Across an Oxic-Anoxic Soil-Water Interface Using Microdialysis Profilers
Published on: March 24, 2023
Floodplain soils contamination assessment using the sequential extraction method of heavy metals from past mining
Radoslava Kanianska1, Jozef Varga2, Nikola Benková2
1Faculty of Natural Sciences, Matej Bel University Banská Bystrica, Tajovského 40, 974 01, Banská Bystrica, Slovakia. radoslava.kanianska@umb.sk.
Abstract:
Floodplains are among the most precious and threatened ecosystems in the world. The study deals with floodplain soil contamination caused by 8 heavy metals (HMs) (Cd, Co, Cr, Cu, Mo, Ni, Pb, Zn) originating and transported from old mine works along the Štiavnica River in Slovakia. We determined the total HMs content and the HM fractions using BCR sequential extraction method. We selected 12 alluvial sites (AS), two contaminated sites (CS), and one reference site (RS). The sampling points were located within the riparian zones (RZ), arable lands (AL), and grasslands (GL). We confirmed soil contamination by HMs and the related ecological risk by different factors. The contamination by HMs at many AS localities was similar or even higher than at CS localities. The highest contamination factor was calculated for Cu (39.8), followed by Pb (27.4), Zn (18.2), and Cd (7.2). The HMs partitioning in the different fractions at the CS and AS localities revealed that Cd, Zn, and Pb were mainly associated with the exchangeable and reducible fractions, while Cu was mainly associated with the oxidisable fraction. The soil properties were selectively correlated with the HM fractions. Based on the ANOVA results, the effect of different ecosystem types on HM fractions was revealed.
More Related Videos
10:44Clean Sampling and Analysis of River and Estuarine Waters for Trace Metal Studies
Published on: July 1, 2016
10:31Detection and Recovery of Palladium, Gold and Cobalt Metals from the Urban Mine Using Novel Sensors/Adsorbents Designated with Nanoscale Wagon-wheel-shaped Pores
Published on: December 6, 2015
Related Concept Videos
Extraction: Advanced Methods
Precipitation and Co-precipitation
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...