Related Experiment Video
Updated: Oct 2, 2025

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
Published on: March 22, 2019
High-power near-infrared QEPAS sensor for ppb-level acetylene detection using a 28 kHz quartz tuning fork and 10 W
Abstract:
A high-power near-infrared (NIR) quartz enhanced photoacoustic spectroscopy (QEPAS) sensor for part per billion (ppb) level acetylene (C2H2) detection was reported. A 1536 nm distributed feedback (DFB) diode laser was used as the excitation light source. Cooperated with the laser, a C-band 10 W erbium-doped fiber amplifier (EDFA) was employed to boost the optical excitation power to improve QEPAS detection sensitivity. A pilot line manufactured quartz tuning fork (QTF) with a resonance frequency of 28 kHz was used as the photoacoustic transducer. In the case of high excitation power, gas flow effect and temperature effect were found and studied. Benefitting from the low QTF resonance frequency, high excitation power, and vibrational-translational (V-T) relaxation promoter, a detection limit of ∼7 ppb was achieved for C2H2 detection, corresponding to a normalized noise equivalent absorption coefficient of 4.4×10-8cm-1 · W · Hz-1/2.
Related Concept Videos
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used....
Gas Chromatography: Types of Detectors-II
Atomic Emission Spectroscopy: Lab
Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle
The ions and electrons produced interact with the fluctuating magnetic field created by a water-cooled...
Flame Photometry: Overview
Atomic Emission Spectroscopy: Instrumentation

