Related Experiment Video
Updated: Oct 2, 2025

Tracking Infiltration Front Depth Using Time-lapse Multi-offset Gathers Collected with Array Antenna Ground Penetrating Radar
Published on: May 1, 2018
Dark/bright band of a melting layer detected by coherent Doppler lidar and micro rain radar
Abstract:
Observation of a melting layer using a 1.55 µm coherent Doppler lidar (CDL) is first presented during a stratiform precipitation event. Simultaneous radar measurements are also performed by co-located 1.24 cm micro rain radar (MRR) and 10.6 cm Doppler weather radar (DWR). As a well-known bright band in radar reflectivity appears during precipitation, an interesting dark band about 160 m below that in lidar backscattering is observed. Due to the absorption effect, the backscattering from raindrops at 1.55 µm is found much weaker than that at short wavelengths usually used in direct detection lidars. However, the CDL provides additional Doppler information which is helpful for melting layer identification. For example, a spectrum bright band with broadened width and sign conversion of skewness is detected in this case. After a deep analysis of the power spectra, the aerosol and precipitation components are separated. The fall speed of hydrometeors given by CDL is found smaller than that of MRR, with the differences of approximately 0.5 m/s and 1.5 m/s for the snow and rainfall, respectively. To illustrate the influence of absorption effect, simulations of the backscatter coefficient and extinction coefficient of aerosol and rainfall are also performed at the wavelength range of 0.3 ∼ 2.2 µm using the Mie theory.
More Related Videos
10:42Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
Published on: March 22, 2019
09:46Direct Comparison of Hyperspectral Stimulated Raman Scattering and Coherent Anti-Stokes Raman Scattering Microscopy for Chemical Imaging
Published on: April 28, 2022
Related Concept Videos
Precipitation Gravimetry
In determining nickel by gravimetric analysis, a precipitant of ethanolic dimethylglyoxime is added to a hot nickel salt solution. This is quickly followed by the dropwise addition of dilute ammonia solution until precipitation occurs. A...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...