Thiosulfate as external electron donor accelerating denitrification at low temperature condition in S⁰-based...

This study was carried out to determine the inhibition of low temperature on the performance of S⁰-based autotrophic denitrification (S⁰-SAD) biofilter, and proposed to enhance the nitrate removal efficiency with thiosulfate as external electron donor. With the decline of temperature from 30 °C to 10 °C at 0.25 h of empty bed contact time (EBCT), the nitrate removal rate presented a logarithmical drop, and the effluent nitrate dramatically increased from 9.19 mg L^-1 to 15.13 mg L^-1. EBCT was prolonged until 0.33 h for 20 °C, 0.66 h for 15 °C and 1.5 h for 10 °C, respectively, to maintain the effluent nitrate below 10 mg L^-1. Such excessive variation of EBCT for different temperature is undoubtedly incredible for practical engineering. Thiosulfate, as the external electron donor, was adopted to compensate the efficiency loss during temperature decrease, which significantly prompted nitrate removal rate to 0.59, 0.53 and 0.31 kg N m^-3 d^-1 at 20 °C, 15 °C and 10 °C conditions, respectively, even at a short EBCT of 0.25 h. It not only acted as compensatory electron donor for nitrate removal, but also promoted the contribution of elemental sulfur via accelerating the DO consumption and extended larger effective volume of S⁰-layer for denitrification. Meanwhile, the significant enrichment of Sulfurimonas and Ferritrophicum provided biological evidences to the enhancement process. However, the incomplete consumption of thiosulfate was observed especially at EBCT of 0.25 h and 10 °C, and the thiosulfate runoff needs to be concerned in case of contaminating the effluent. Herein, approximately extending EBCT to 0.66 h and decreasing thiosulfate dosage were conducted simultaneously, thereby achieving 100% thiosulfate utilization efficiency and expected nitrate removal. This study provided a fundamental guidance to design and operate S⁰-SAD biofilter in response to seasonal temperature variation for practical engineering.