Study of Wear Phenomenon of a Dental Milling Cutter by Statistical-Mathematical Modeling Based on the Experimental...

The wear phenomenon of a dental milling cutter is studied based on experimental results and data and validated by statistical-mathematical modeling. The results of the statistical-mathematical modeling by the interpolation of the experimental results (data) regarding the wear of the dental milling cutter analyzed and obtained in the work process are presented in this paper. These results (data) are important because they lead to polynomial functions which by interpolation approximate very well the dependent parameter, specifically the wear process (mass lost due to dental milling cutter wear, m), considered in the experimental program. The polynomial interpolation functions are valid, only during the experimental testing range of the dental milling cutter, to describe the wear phenomenon; the extrapolations do not lead to satisfactory results. However, by using a controlled interpolation function with an exponential component, the extrapolation of the results is possible. Therefore, the purpose of this paper is the statistical-mathematical modeling by the interpolation of the experimental results of the mass lost due to dental milling cutter wear, m, using the deterministic differential model for the work process of it. Thus, interesting conclusions can be drawn relating to the phenomenon. In support of these statements come the results of the statistical-mathematical modeling by the interpolation of the experimental data obtained in the work process of the dental milling cutters, leading to practical applications, such as the extension of the life of dental milling cutter, useful even for its operation optimization; determination of possible criteria for replacing the worn dental milling cutters; the extension of the life of the materials from which dental milling cutters are built; or the provision of ideas for constructive solutions. Based on the modeling results by interpolation, it was found that the dental milling cutter during the milling operation works with high efficiency (mass loss due to wear is very reduced) in the first 11 h of operation, i.e., about a 10% increase in lifetime. After 11 h of operation, mass loss due to wear of the dental milling cutter increases relatively exponentially; thus, it is recommended that, in the normal way, the dental milling cutter be replaced with a new one to ensure high standards of materials processing.