Related Experiment Video
Updated: Sep 30, 2025

A Simple Migration/Invasion Workflow Using an Automated Live-cell Imager
Published on: February 2, 2019
Task Migration and Scheduler for Mixed-Criticality Systems
Jeanseong Baik1, Jaewoo Lee2, Kyungtae Kang1
1Department of Computer Science and Engineering, Hanyang University, Seoul 04763, Korea.
Abstract:
The interference between software components is increasing in safety-critical domains, such as autonomous driving. Low-criticality (LC) tasks, such as vehicle communication, may control high-criticality (HC) tasks, such as acceleration. In such cases, the LC task should also be considered as an HC task because the HC tasks relies on the LC task. However, the difficulty in guaranteeing these LC tasks is the catastrophic cost of computing resources, the electronic control unit in the domain of vehicles, required for every task. In this paper, we theoretically and practically provide safety-guaranteed and inexpensive scheduling for LC tasks by borrowing the computational power of neighbored systems in distributed systems, obviating the need for additional hardware components. As a result, our approach extended the schedulability of LC tasks without violating the HC tasks. Based on the deadline test, the compatibility of our approach with the task-level MC scheduler was higher than that of the system-level MC scheduler, such that the task-level had all dropped LC tasks recovered while the system-level only had 25.5% recovery. Conversely, from the worst-case measurement of violated HC tasks, the HC tasks were violated by the task-level MC scheduler more often than by the system-level MC scheduler, with 70.3% and 15.4% average response time overhead, respectively. In conclusion, under the condition that the HC task ratio has lower than 47% of the overall task systems at 80% of total utilization, the task-level approach with task migration has extensively higher sustainability on LC tasks.
Related Concept Videos
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by:
Cyclic Processes And Isolated Systems
In the case of a non-isolated system, the change in the internal energy is zero only if the process is cyclic. A thermodynamic process is considered cyclic if the system undergoes a series of changes and returns to its initial state.
Consider a cyclic process that returns to its initial state, undergoing a four-step process. The heat transfer along each...
Cytoskeletal Coordination in Cell Migration
Migration
Distribution Reliability and Automation
Simplified Synchronous Machine Model
In this model, each generator is connected to a...

