A likely geological record of deep tremor and slow slip events from a subducted continental broken formation

Francesco Giuntoli1, Giulio Viola2

  • 1Department of Biological, Geological and Environmental Sciences, Università degli Studi di Bologna, Bologna, Italy. francesco.giuntoli@unibo.it.

Scientific Reports
|March 17, 2022
PubMed

Related Concept Videos

The Fossil Record02:56

The Fossil Record

The fossil record documents only a small fraction of all organisms that have ever inhabited Earth. Fossilization is a rare process, and most organisms never become fossils. Moreover, the fossil record only exhibits fossils that have been discovered. Nevertheless, sedimentary rock fossils of long-lived, abundant, hard-bodied organisms dominate the fossil record. These fossils offer valuable information, such as an organism's physical form, behavior, and age. Studying the fossil record helps...
26.0K
Fault Types01:18

Fault Types

When analyzing a single line-to-ground fault from phase A to ground at a three-phase bus, it is important to consider the fault impedance. This impedance is zero for a bolted fault, equal to the arc impedance for an arcing fault, and represents the total fault impedance for a transmission-line insulator flashover. To derive sequence and phase currents, fault conditions are translated from the phase domain to the sequence domain.
For line-to-line faults occurring between phases B and C, the...
135
Global Climate Change01:50

Global Climate Change

Throughout its ~4.5 billion year history, the Earth has experienced periods of warming and cooling. However, the current drastic increase in global temperatures is well outside of the Earth’s cyclic norms, and evidence for human-caused global climate change is compelling. Paleoclimatology, the study of ancient climate conditions, provides ample evidence for human-caused global climate change by comparing recent conditions with those in the past.
24.9K
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
205