What Is the Alignment and Balance of a Total Knee Arthroplasty Performed Using a Calipered Kinematic Alignment...

We simulated calipered kinematic alignment total knee arthroplasty (cKATKA) using alignment data and ligament tensions acquired during 607 consecutive robotic-assisted TKAs performed using a dynamic ligament tensor. The distal femur was resected parallel to the native joint line accounting for cartilage loss. The proximal tibial resection necessary to achieve extension gap balance was calculated for each knee. Similarly, symmetric posterior condylar resections prescribed by this method were simulated and the tibial resection needed to achieve a balanced flexion gap calculated. Finally, the resultant limb alignment and degree of joint balance in both flexion and extension of each knee were determined and categorized according to the preoperative knee alignment.

Increasing preoperative varus deformity required a greater tibial varus cut to achieve a balanced extension gap (P < .0001). There was no correlation between tibial varus angle and flexion gap balance (P > .1). For mild varus deformities 81% and 95% of knees could be balanced and have an overall limb alignment within 3° and 5° from the mechanical axis respectively. For knees with moderate-severe varus, only 37% and 74% could be balanced within these alignment boundaries (P < .01). Overall, 95% of these simulated knees could be balanced with an overall alignment within 0° ± 5°. However, 50% of the simulated TKAs had looser medial gaps in flexion compared to the lateral gap.

Application of the cKATKA method can yield TKAs within 0° ± 5° of mechanical axis alignment by simply adjusting the proximal tibial resection without ligament releases. However, an undesirable flexion gap balance was predicted in nearly 50% of the TKAs.