Long-term stability of clopidogrel solid dispersions-Importance of in vitro dissolution test

Formulation of solid dispersions (SDs), in which the drug substance is dissolved or dispersed inside a polymer matrix, is one of the modern approaches to increase the solubility and dissolution rate of poorly soluble active pharmaceutical ingredients (APIs), such as clopidogrel. In the form of a free base, clopidogrel is unstable under increased both high moisture and temperature, so it is most often used as its salt form, clopidogrel hydrogen sulfate (CHS).The aim of this study was the formulation, characterization, and long-term stability investigation of CHS solid dispersions, prepared with four different hydrophilic polymers (poloxamer 407, macrogol 6000, povidone, copovidone) in five API/polymer ratios (1:1, 1:2, 1:3, 1:5, 1:9). SDs were prepared by the solvent evaporation method, employing ethanol (96% v/v) as a solvent. Initial results of the in vitro dissolution test showed an increase in the amount of dissolved CHS from all prepared SD samples compared to pure CHS, corresponding physical mixtures (PMs), and commercial tablets. SDs, prepared with poloxamer 407, macrogol 6000, and copovidone, at CHS/polymer ratios 1:5 and 1:9, notably increased the amount of dissolved CHS (> 80%, after 60 min), thus they were selected for further characterization. To assess the SDs long-term stability, in vitro dissolution studies, clopidogrel content determination, differential scanning calorimetry (DSC), and Fourier transform infrared spectroscopy (FT-IR) were performed initially and after 12 months of long-term stability studies under controlled conditions (25°C, 60% RH) meeting the ICH guideline Q1A (R2) requirements. The clopidogrel content in the selected samples was very similar at the beginning (96.13% to 99.93%) and at the end (95.98% to 99.86%) of the conducted test. DSC curves and FT-IR spectra of all SD samples after 12 months of stability study, showed the absence of CHS crystallization, which is an indication of good stability. However, the in vitro dissolution test showed a considerable reduction in CHS released from SDs with macrogol 6000. The amount of dissolved CHS from SDs with macrogol 6000 was initially 94.02% and 92.01%, and after 12 months of stability study, only 65.13% and 49.62%. In contrast, the amount of dissolved CHS from SDs prepared with poloxamer 407 and copovidone was very similar after 12 months of the stability study compared to the initial values. Results obtained indicated the great importance of the in vitro dissolution test in determining the long-term stability and quality of SDs.