Related Experiment Video
Updated: Sep 28, 2025

A Modified Lean and Release Technique to Emphasize Response Inhibition and Action Selection in Reactive Balance
Published on: March 19, 2020
Neck Loads During Head-First Entries into Trampoline Dismount Foam Pits: Considerations for Trampoline Park Safety
Tom Whyte1,2,3, Edward Lind4,5, Adam Richards6
1Neuroscience Research Australia, Margarete Ainsworth Building, 139 Barker St, Randwick, NSW, 2031, Australia. t.whyte@neura.edu.au.
Abstract:
Serious cervical spine injuries have been documented from falls into foam pits at trampoline parks. To address the lack of evidence on how foam pits should be designed for mitigating neck injury risk, this study aimed to quantify neck loads during head-first entry into varying foam pit designs. An instrumented Hybrid III anthropomorphic test device was dropped head-first from a height of up to 1.5 m into three differently constructed foam pits, each using a different mechanism to prevent direct contact between the falling person and the floor (foam slab, trampoline or net bed). Measured neck loads were compared to published injury reference values. In the simplest, foam-only pit design, increasing foam depth tended to reduce peak compressive force. At least one injury assessment reference metric was exceeded in all pit conditions tested for 1.5 m falls, most commonly the time-dependent neck compression criterion. The results highlight the importance of adequate foam depth in combination with appropriate pit design in minimizing injury risk. The risk of cervical spine injury may not be reduced sufficiently with current foam pit designs.
Related Concept Videos
Cardiopulmonary Resuscitation II: ACLS Airway Management
Free-falling Bodies: Example
The...
Hydraulic Jump
Design Example: Designing Water Slide
Bernoulli's principle determines the water's velocity along the...
Hydraulic Jump: Problem Solving
Personal Protective Equipment

