Finite-time H∞ synchronization control for coronary artery chaos system with input and state time-varying delays
Charuwat Chantawat1, Thongchai Botmart1
1Department of Mathematics, Faculty of Science, Khon Kaen University, Khon Kaen, Thailand.
Abstract:
This is the first time for studying the issue of finite-time H∞ synchronization control for the coronary artery chaos system (CACS) with input and state time-varying delays. Feedback control is planned for finite-time of synchronization CACS. By constructing the Lyapunov-Krasovskii functional (LKF) is derived for finite-time stability criteria of CACS with interval and continuous differential time-varying delays. We use Wirtinger-based integral inequality to evaluate the upper bound of the time derivative of the LKF. We apply the single integral form and the double integral form of the integral inequality, according to Wirtinger-based integral inequality, to ensure that the feedback controller for synchronization has good performance with disturbance and time-varying delay. The new sufficient finite-time stability conditions have appeared in the form of linear matrix inequalities (LMIs). Numerical checks can be performed using the LMI toolbox in MATLAB. A numerical example is presented to demonstrate the success of the proposed methods. This resultant is less conservative than the resultants available in the previous works.
More Related Videos
Related Concept Videos
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Classification of Systems-II
BIBO stability of continuous and discrete -time systems
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system....
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Basic Continuous Time Signals
The unit step function, denoted u(t), is zero for negative time values and one for positive time values, exhibiting a discontinuity at t=0. This function often represents abrupt changes, such as the step voltage introduced when turning a car's...


