Effect of application mode (capping and amendment) on the control of cadmium release from sediment by apatite/calcite...

In this research, the influence of application mode (capping and amendment) on the control of cadmium (Cd) liberation from sediment by apatite/calcite mixture and its phosphorus release risk were investigated. The results showed that calcite addition had a limited effect on the speciation of Cd in sediment, but apatite addition had a significant impact on the fractionation of Cd in sediment. Apatite amendment could effectively immobilize the most readily mobilized Cd by transferring the acid-soluble fraction to the reducible and residual fractions. Apatite addition also could effectively reduce the concentration of toxicity characteristic leaching procedure (TCLP)-leachable Cd in sediment, and apatite had a much higher reduction efficiency of TCLP-leachable Cd than calcite. Apatite/calcite mixture capping could reduce the risk of Cd liberation from sediment into the overlying water, and the controlling efficiency of apatite/calcite mixture capping was higher than that of apatite/calcite mixture amendment. The effect of apatite/calcite mixture addition on the concentration of reactive soluble phosphorus (SRP) in the overlying water was limited. The introduction of calcite into the apatite capping layer could lower the risk of phosphorus release from apatite to the overlying water as compared to single apatite capping. However, the apatite/calcite mixture capping layer still had a relatively high risk of phosphorus liberation into the overlying water. Results of this work suggest that apatite/calcite mixture has a high potential to be used as a capping material to control Cd release from sediment from the perspective of controlling efficiency and application convenience.