Changes in metal adsorption ability of microplastics upon loss of calcium carbonate filler masterbatch through...

CaCO₃ filler masterbatch (CFM) is one of the most commonly used fillers in polypropylene (PP) and polyethylene (PE) products, and its is used to enhance the toughness of the polymer matrix. This is the first study to investigate the loss of CaCO₃ and its impact on the adsorption ability of microplastics from plastic woven bags throughout the natural aging process. PP wire (PPw, 85% PP + 15% CFM) and PE film (PEf, 80% PE + 20% CFM) samples from plastic woven bags underwent a 250 d aging process in an open-air environment. Changes in the surface properties, morphology, CaCO₃ content, and density of PPw microplastics (PPw-MP) and PEf microplastics (PEf-MP) after various durations of aging were investigated by scanning electron microscopy, infrared spectroscopy, and thermogravimetric analysis. The results showed that CaCO₃ separated and agglomerated on the surfaces of PPw-MP and PEf-MP after 30 d. After 250 d, 42% of CaCO₃ was lost from PPw-MP and 28% was lost from PEf-MP, decreasing the density of the microplastic samples. CFM presented a considerably higher adsorption affinity toward Cu(II) than PP particles and PE particles; therefore, its presence in plastic matrix increased the adsorption ability of the products. The adsorption of Cu(II) on PPw-MP and PEf-MP decreased with aging because of the loss of CaCO₃ and poor development of O-containing functional groups. The q_m value (maximum adsorption quantity of Langmuir model) decreased from 11.01 mg/g in unaged PPw-MP to 1.35 mg/g in aged PPw-MP, and from 9.00 mg/g in unaged PEf-MP to 1.05 mg/g in aged PEf-MP. Overall, the findings demonstrate that CaCO₃ was crucial for the heavy metal-plastic interactions of the samples. Therefore, the results provide a basis to further clarify the potential environmental risks of plastic woven bags associated with heavy metal mobility.