Deep Learning with Discriminative Margin Loss for Cross-Domain Consumer-to-Shop Clothes Retrieval

Pendar Alirezazadeh1, Fadi Dornaika1,2,3, Abdelmalik Moujahid4

  • 1Department of Informatics, University of the Basque Country, 20008 Donostia-San Sebastian, Spain.

Related Concept Videos

Survival Tree01:19

Survival Tree

Survival trees are a non-parametric method used in survival analysis to model the relationship between a set of covariates and the time until an event of interest occurs, often referred to as the "time-to-event" or "survival time." This method is particularly useful when dealing with censored data, where the event has not occurred for some individuals by the end of the study period, or when the exact time of the event is unknown.
 Building a Survival Tree
Constructing a...
172
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
7.2K
Reducing Line Loss01:18

Reducing Line Loss

In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss...
209
Margin of Error01:27

Margin of Error

The margin of error is also called the maximum error of an estimate. The margin of error is the maximum possible or expected difference between the observed sample parameter value and the actual population parameter value. For proportion, it is the maximum difference between the value of sample proportion obtained from the data and the true value of population proportion. As the true value of the population parameter is not known, the margin of error is calculated using the sample statistic.
4.6K
Aggregates Classification01:29

Aggregates Classification

Aggregate classification is generally based on its size, petrographic characteristics, weight, and source. Size classification ranges from coarse to fine aggregates, defined by the size of the particles. Coarse aggregates are particles that do not pass through ASTM sieve No. 4, and aggregates that pass through the sieve are fine aggregates.
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
400
Predicting Products: Substitution vs. Elimination02:52

Predicting Products: Substitution vs. Elimination

When a nucleophile and an alkyl halide react, nucleophilic substitution and β-elimination reactions compete to generate products.
The following factors can influence the mechanisms competing against each other:
12.4K