Finite element analysis of a hybrid corrugated hip implant for stability and loading during gait phases

Implants used in total hip replacements (THR) exhibit high failure rates and up to a decade of operational life. These surgical failures could be mainly attributed to the improper positioning, post-surgical stability and loading, of the implants during different phases of the gait. Typically, revised surgeries are suggested within a few years of hip implantation, which requires multiple femoral drilling operations to remove an existing implant, and to install a new implant. The pain and trauma associated with such procedures are also challenging with the existing hip implants. In this work, we designed a novel corrugated hip implant with innovative dimensioning as per ASTM standards, and grooves for directed insertion and removal (using a single femoral drilling and positioning operation). Biocompatible titanium alloy (Ti6Al4V) was chosen as the implant material, and the novel implant was placed into a femur model through a virtual surgery to study its stability and loading during a dynamic gait cycle. A detailed mesh convergence study was conducted to select a computationally accurate finite element (FE) mesh. Tight fit and frictional fit attachment conditions were simulated, and the gait induced displacements and stresses on the implant, cortical and cancellous bone sections were characterized. During walking, the implant encountered the maximum von-Mises stress of 254.97 MPa at the femoral head. The analyses indicated low micro-motions (i.e., approximately 7μm) between the femur and implant, low stresses at the implant and bone within elastic limits, and uniform stress distribution, which unlike existing hip implants, would be indispensable for bone growth and implant stability enhancement, and also for reducing implant wear.