Cumulative advantage and citation performance of repeat authors in scholarly journals

Kyle Siler1, Philippe Vincent-Lamarre1, Cassidy R Sugimoto2

  • 1École de Bibliothéconomie et des Sciences de l'information, Université de Montréal, Montréal, Québec, Canada.

Plos One
|April 13, 2022
PubMed

Related Concept Videos

Chi-square Analysis02:46

Chi-square Analysis

The chi-square test is a statistical hypothesis test. It is used to check whether there is a significant difference between an expected value and an observed value. In the context of genetics, it enables us to either accept or reject a hypothesis, based on how much the observed values deviate from the expected values.
The chi-square test was developed by Pearson in 1990.
The first step of performing a Chi-square analysis is to establish a null hypothesis, which assumes that there is no real...
Cumulative Frequency Distribution01:04

Cumulative Frequency Distribution

A cumulative frequency distribution is another type of frequency distribution. Instead of reporting how many data values fall in some classes, it reports how many data values are contained in either that class or any class to its left. Technically, it means the sum of frequencies of the class and all the classes below it in a frequency distribution. A cumulative frequency is calculated by adding the frequency of each class lower than the corresponding class interval or category. In general, a...
Outliers and Influential Points01:08

Outliers and Influential Points

An outlier is an observation of data that does not fit the rest of the data. It is sometimes called an extreme value. When you graph an outlier, it will appear not to fit the pattern of the graph. Some outliers are due to mistakes (for example, writing down 50 instead of 500), while others may indicate that something unusual is happening. Outliers are present far from the least squares line in the vertical direction. They have large "errors," where the "error" or residual is the vertical...
Statistical Analysis: Overview01:11

Statistical Analysis: Overview

When we take repeated measurements on the same or replicated samples, we will observe inconsistencies in the magnitude. These inconsistencies are called errors. To categorize and characterize these results and their errors, the researcher can use statistical analysis to determine the quality of the measurements and/or suitability of the methods.
One of the most commonly used statistical quantifiers is the mean, which is the ratio between the sum of the numerical values of all results and the...
First Pass Effect01:12

First Pass Effect

Presystemic elimination, or the first-pass effect, is the metabolism of drugs that reduces their effective concentration at the site of action. Apart from the first-pass effect, the systemic bioavailability of the drug is also reduced by other factors, including incomplete absorption or chemical degradation of drugs.
Depending on the route of administration, drugs can be metabolized in the liver, intestine, lungs, and vasculature. Orally administered drugs are first absorbed through the...
Average Power01:13

Average Power

In practical electrical applications, the concept of time-varying instantaneous power is not frequently utilized. Instead, focus shifts to the more practical quantity known as average power. Average power is determined by integrating the instantaneous power over a specified time period and subsequently dividing it by that duration.