Related Experiment Video
Updated: Jun 20, 2026

Synthesis and Characterization of Functionalized Metal-organic Frameworks
Published on: September 5, 2014
Synthesis and characterization of MgF2-CoF2 binary fluorides. Influence of the treatment atmosphere and temperature
Mariusz Pietrowski1, Michał Zieliński1, Emilia Alwin1
1Adam Mickiewicz University in Poznań, Faculty of Chemistry Umultowska 89B 61-614 Poznan Poland mariop@amu.edu.pl.
Abstract:
Research was carried out on the incorporation of divalent cobalt cations into the crystalline structure of MgF2 to form Mg Co1- F2 binary fluorides, which had not been investigated before. The above fluorides were obtained by the precipitation from aqueous solution of magnesium and cobalt nitrates with ammonium fluoride. Binary fluorides containing 0.6, 7.5 and 37.7 mol% CoF2 were prepared. The effects of treatment temperature (300, 400 °C) and atmosphere (oxidizing or reducing) on the structure (XRD, TPR-H2, UV-Vis), texture (low-temperature N2 adsorption), surface composition (XPS) and surface acidity (NH3-TPD) of the binary fluorides were determined. It has been found that in Mg Co1- F2 an isomorphic substitution occurs of Mg2+ cations by Co2+ cations which results in the formation of a rutile-type solid solution. The obtained binary fluorides are characterized by a mesoporous structure and relatively large surface area. It has been found that thermal treatment of the binary fluorides in oxidizing conditions results in the oxidation of CoF2 to Co3O4 even at 300 °C; therefore it is not possible to obtain pure Mg Co1- F2 binary fluorides in the presence of air. The preparation of the latter requires reducing conditions, namely thermal treatment of dry precipitate at 300 °C in an atmosphere of hydrogen. If the treatment is conducted at a higher temperature (400 °C), CoF2 undergoes a partial reduction to metallic cobalt. An XPS study has shown the presence of hydroxyl groups in the investigated samples. However, these are solely surface groups because their presence was not detected by XRD measurements. The binary fluorides obtained by our method are characterized by a very narrow optical energy gap (5.31-3.50 eV), considerably narrower than that recorded for bulk fluorides. Measurements of temperature-programmed desorption of ammonia have shown that the incorporation of cobalt cations into the crystal structure of MgF2 results in a decrease in the surface acidity of the binary fluorides.
More Related Videos
08:42Microfluidic-based Synthesis of Covalent Organic Frameworks COFs: A Tool for Continuous Production of COF Fibers and Direct Printing on a Surface
Published on: July 10, 2017
08:55Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses
Published on: June 7, 2018