Related Experiment Video
Updated: Sep 24, 2025

Synthesis of Programmable Main-chain Liquid-crystalline Elastomers Using a Two-stage Thiol-acrylate Reaction
Published on: January 19, 2016
Onium salts improve the kinetics of photopolymerization of acrylate activated with visible light
Janina Kabatc1, Katarzyna Iwińska1, Alicja Balcerak1
1University of Science and Technology, Faculty of Chemical Technology and Engineering Seminaryjna 3 85-326 Bydgoszcz Poland nina@utp.edu.pl +48 52 374 9005 +48 52 374 9112.
Abstract:
The aim was study the influence of onium salts on the kinetics of photopolymerization in the visible light region. Trimethylolpropane triacrylate TMPTA was selected as a monomer, and activated by 1,3-bis(phenylamino)squaraine (SQ) used as a photosensitizer in addition to tetramethylammonium n-butyltriphenylborate (B2). The iodonium salt [A-I-B]+X- functioned as a second radical initiator, bearing a different substitution pattern for the cation. The ternary system was formulated with different concentrations of both borate and diphenyliodonium salts. Differential scanning calorimetry was used to investigate the polymerization reaction over the photoactivation time carried out at 300 nm < λ < 500 nm irradiation. When the squaraine dye/borate salt was used as photoinitiator, a slow polymerization reaction was observed and a lower monomer conversion. The addition of a third component (onium salt) increased the polymerization rate and conversion. Ternary photoinitiator systems showed improvement in the polymerization rate of triacrylate leading to high conversion in a short photoactivation time. The photoinitiating ability of bi- and tri-component photoinitiators acting in the UV-Vis region for initiation polymerization of triacrylate was compared with those of some commercially used photoinitiating systems. It was also found, that, the parallel electron transfer from an excited state of the sensitizer to [A-I-B]+X-, and an electron transfer from a ground state of R(Ph)3B-N(CH3)4 + to an excited state of the sensitizer results in two types of initiating radical.
More Related Videos
05:47Preparation of Polyoxometalate-based Photo-responsive Membranes for the Photo-activation of Manganese Oxide Catalysts
Published on: August 7, 2018
06:49Atom Transfer Radical Polymerization of Functionalized Vinyl Monomers Using Perylene as a Visible Light Photocatalyst
Published on: April 22, 2016
Related Concept Videos
Anionic Chain-Growth Polymerization: Overview
Leveling Effect and Non-Aqueous Acid-Base Solutions
The Leveling Effect of a Solvent
A generic acid (HA) reacts with the generic base (B-) to yield the corresponding conjugate base (A-) and conjugate acid (HB):
Leveling Effect
Acidity of 1-Alkynes
The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.
Olefin Metathesis Polymerization: Acyclic Diene Metathesis (ADMET)
Similar to cross-metathesis, ADMET also involves the formation of metallacyclobutane intermediate by [2+2] cycloaddition of one of the double bonds of a terminal diene with...
Cationic Chain-Growth Polymerization: Mechanism