Investigating the draw ratio and velocity of an electrically charged liquid jet during electrospinning

The investigation of the draw ratio and velocity of an electrospinning polymer solution jet is of great interest for understanding the formation of nanofibers. During the electrospinning process, the charged polymer solution jets were stretched by electric force, resulting in the formation of ultrathin fibers. In this study, theoretical deduction and experimental calculation were applied to evaluate the velocities and draw ratios of the charged jets at different electrospinning stages. Depending on the diameter of the charged jets at different electrospinning stages, the velocities and draw ratios of the charged jets were calculated with values far lower than the data in a previous report. The theoretical calculation was compared with experimental data using polyamic acid as a model polymer for electrospinning. The results indicated that during electrospinning, as the collecting distance was increased from 0 to 30 cm, the diameter of the electrospinning jet decreased from 18 800 nm to a constant value of around 245 nm, the solvent in the jet decreased from 96.50 wt% to 25.45 wt%, and the density of the jet increased from 0.9504 to 1.0995 g cm^-3. These parameters led to the draw ratio and velocity of the jet experiencing first an increase and then a decrease in the value, and the highest draw ratio and velocity were 869 and 867 m s^-1, respectively, which are quite different from the data in previous reports.