Related Experiment Video
Updated: Sep 24, 2025

Preparation of Large-area Vertical 2D Crystal Hetero-structures Through the Sulfurization of Transition Metal Films for Device Fabrication
Published on: November 28, 2017
Synthesis, characterization, X-ray and electronic structures of diethyl ether and 1,2-dimethoxyethane adducts of
Thomas E Shaw1,2, Timothy J Diethrich3, Charlotte L Stern4
1Department of Chemistry, University of Central Florida, Orlando, FL 32816, USA. titel.jurca@ucf.edu.
Abstract:
The bis(diethyl ether) and 1,2-dimethoxyethane (dme) adducts of molybdenum(IV) chloride and tungsten(IV) chloride are valuable starting materials for a variety of synthetic inorganic and organometallic reactions. Despite the broad utility and extensive use of these 6-coordinate complexes, their syntheses remain unoptimized, and their characterization incomplete after more than three decades. While exploring the ligand exchange behaviour of trans-MoCl4(OEt2)2, we obtained single crystals of this red-orange complex and subsequently compared its structural parameters with those of the recently reported trans-WCl4(OEt2)2. Significantly improved procedures for both MoCl4(dme) and WCl4(dme) were developed, and X-ray diffraction data were obtained and analysed. The magnetic properties of the dme adducts were probed, both with Gouy and SQUID magnetometry measurements. The magnetic moment of WCl4(dme) was smaller than that of MoCl4(dme), an observation that we attribute to the greater spin-orbit coupling of tungsten. Electronic structure studies were also conducted to probe the preferential trans configuration of the diethyl ether adducts and to assign the UV-Vis spectra of the dme adducts.
More Related Videos
Related Concept Videos
Electrophilic 1,2- and 1,4-Addition of X2 to 1,3-Butadiene
Predicting Molecular Geometry
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
Formation of Halohydrin from Alkenes
Electrophilic 1,2- and 1,4-Addition of HX to 1,3-Butadiene
Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent...

