A letter is not enough: Women's preferences for and experiences of receiving breast density information

Nancy R Kressin1, Jolie B Wormwood2, Tracy A Battaglia1

  • 1Section of General Internal Medicine, Department of Medicine, Boston University School of Medicine, Boston, MA, USA.

Abstract

Related Concept Videos

Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
16.1K
Density and Archimedes' Principle01:05

Density and Archimedes' Principle

When a lump of clay is dropped into water, it sinks. But if the same lump of clay is molded into the shape of a boat, it starts to float. Because of its shape, the clay boat displaces more water than the lump and experiences a greater buoyant force, even though its mass is the same. The same holds true for steel ships. The average density of an object majorly determines if the object will float. If an object's average density is less than that of the surrounding fluid, it will float. The...
7.5K
Bulk Density of Aggregate01:22

Bulk Density of Aggregate

Bulk density refers to the mass of aggregate particles that would fill a unit volume. The concept of bulk density originates from the inability to pack aggregate particles in a manner that completely eliminates void spaces. Hence, the term bulk refers to the volume that encompasses both the aggregates and the voids. This measurement is crucial when aggregates are batched by volume and is used to convert quantities by mass to volume.
Most natural mineral aggregates, like sand and gravel,...
701
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
4.4K
Dose-Response Relationship: Overview01:03

Dose-Response Relationship: Overview

Agonists can bind with and activate receptors, resulting in the formation of drug-receptor complexes. Once formed, these complexes catalyze many biochemical processes at the cellular level and subsequently induce a pharmacologic response. The degree of response is directly proportional to the fraction of activated receptors, which in turn, depends on the concentration of the drug at the receptor site as well as the sensitivity of the receptor. An increase in the administered dose contributes to...
3.8K
Pressure Relationships in Thoracic Cavity01:24

Pressure Relationships in Thoracic Cavity

Breathing, otherwise known as pulmonary ventilation, is the process of air movement into and out of the lungs. The main mechanisms propelling pulmonary ventilation are atmospheric pressure (Patm), intra-pulmonary (Ppul ) or intra-alveolar pressure (Palv) within the alveoli, and intrapleural pressure (Pip) within the pleural cavity.
Breathing Mechanisms
Both intra-alveolar and intrapleural pressures rely on specific lung properties. The ability to breathe—allowing air to enter the lungs...
3.3K