The impact of travelling on the COVID-19 infection cases in Germany

COVID-19 continues to disrupt social lives and the economy of many countries and challenges their healthcare capacities. Looking back at the situation in Germany in 2020, the number of cases increased exponentially in early March. Social restrictions were imposed by closing e.g. schools, shops, cafés and restaurants, as well as borders for travellers. This reaped success as the infection rate descended significantly in early April. In mid July, however, the numbers started to rise again. Of particular reasons was that from mid June onwards, the travel ban has widely been cancelled or at least loosened. We aim to measure the impact of travellers on the overall infection dynamics for the case of (relatively) few infectives and no vaccinations available. We also want to analyse under which conditions political travelling measures are relevant, in particular in comparison to local measures. By travel restrictions in our model we mean all possible measures that equally reduce the possibility of infected returnees to further spread the disease in Germany, e.g. travel bans, lockdown, post-arrival tests and quarantines.

To analyse the impact of travellers, we present three variants of an susceptible-exposed-infected-recovered-deceased model to describe disease dynamics in Germany. Epidemiological parameters such as transmission rate, lethality, and detection rate of infected individuals are incorporated. We compare a model without inclusion of travellers and two models with a rate measuring the impact of travellers incorporating incidence data from the Johns Hopkins University. Parameter estimation was performed with the aid of the Monte-Carlo-based Metropolis algorithm. All models are compared in terms of validity and simplicity. Further, we perform sensitivity analyses of the model to observe on which of the model parameters show the largest influence the results. In particular, we compare local and international travelling measures and identify regions in which one of these shows larger relevance than the other.

In the comparison of the three models, both models with the traveller impact rate yield significantly better results than the model without this rate. The model including a piecewise constant travel impact rate yields the best results in the sense of maximal likelihood and minimal Bayesian Information Criterion. We synthesize from model simulations and analyses that travellers had a strong impact on the overall infection cases in the considered time interval. By a comparison of the reproductive ratios of the models under traveller/no-traveller scenarios, we found that higher traveller numbers likely induce higher transmission rates and infection cases even in the further course, which is one possible explanation to the start of the second wave in Germany as of autumn 2020. The sensitivity analyses show that the travelling parameter, among others, shows a larger impact on the results. We also found that the relevance of travel measures depends on the value of the transmission parameter: In domains with a lower transmission parameter, caused either by the current variant or local measures, it is found that handling the travel parameters is more relevant than those with lower value of the transmission.

We conclude that travellers is an important factor in controlling infection cases during pandemics. Depending on the current situation, travel restrictions can be part of a policy to reduce infection numbers, especially when case numbers and transmission rate are low. The results of the sensitivity analyses also show that travel measures are more effective when the local transmission is already reduced, so a combination of those two appears to be optimal. In any case, supervision of the influence of travellers should always be undertaken, as another pandemic or wave can happen in the upcoming years and vaccinations and basic hygiene rules alone might not be able to prevent further infection waves.