Related Experiment Video
Updated: Sep 23, 2025

Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent
Published on: February 21, 2017
Improvement of water recovery from phosphate sludge at the M'Dhilla Mine, Tunisia
Mouna Ettoumi1, Marouen Jouini2, Carmen Mihaela Neculita3
1Laboratoire Ressources Minérales et Environnement, Mineralogy and Geochemistry Research Group, University of Tunis El Manar, Tunis, Tunisia.
Abstract:
In Tunisia, phosphate beneficiation from ores by the Gafsa Phosphate Company (GPC) is a water-intensive process that generates large amounts of sludge. Responsible mining minimizes water use and prioritizes its recycling and reuse to limit the impact on water resources. Recovery of water from the phosphate sludge (PS) using the densification with adapted flocculants-a low-energy consuming process-is plausible for efficient management of water resources. The objective of this study was to improve low-cost water recovery from PS produced at the M'Dhilla Mine plant operated by GPC in Tunisia. Representative samples of PS were first collected and characterized for physicochemical and mineralogical properties. To maximize water recovery, densification based on flocculation was then performed using two different flocculants (Slim Floc vs Flomin 905) with different doses (0.1 g/L vs 0.3 g/L), consumption (100-1200 g per ton of dry sludge g/tds), sludge concentration (50 g/L vs 60 g/L), and settling time (15-1200 s). Results showed that PS particles were fine-grained and contained carbonates, silicates, and significant residual fluorapatite (59%) that could be valorized. Up to 91% of water was recovered using anionic flocculant Flomin 905. These findings show an improvement of 24% relative to the current water recovery at M'Dhilla plant (66%) while using a flocculant dose three times lower than the conventional flocculent Sim Floc (0.1 g/L vs 0.3 g/L). The best sludge settlement conditions were obtained with 0.1 g/L Flomin 905 at 600 g/tds and 10 min of settling time. The densification process using Flomin 905 proved efficient in maximizing water recovery (91%) with a consumption of flocculant that could be decreased by up to 70% annually in comparison with Slim Floc, thus decreasing treatment costs by 63%. Results will help to prevent exhaustion of groundwater resources and limit land exploitation while decreasing the volume of settling ponds.
More Related Videos
15:19Development of Sulfidogenic Sludge from Marine Sediments and Trichloroethylene Reduction in an Upflow Anaerobic Sludge Blanket Reactor
Published on: October 15, 2015
08:21Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method
Published on: May 18, 2018
Related Concept Videos
Factors Affecting Solubility
Washing, Drying, and Ignition of Precipitates