Effect of pH and titratable acidity on enamel and dentine erosion

Constanza E Fernández1, Ana Carolina S Brandao2, Eloá C Bícego-Pereira2

  • 1Cariology Unit, Department Oral Rehabilitation, Faculty Health Sciences, University of Talca, Talca, Chile.

Abstract

Related Concept Videos

EDTA: Auxiliary Complexing Reagents01:26

EDTA: Auxiliary Complexing Reagents

EDTA titrations are usually carried out in highly basic conditions, where the fully deprotonated form of EDTA, Y4−, actively complexes with the free metal ions in the solution. Several metal ions precipitate as hydrous oxide (hydroxides, oxides, or oxyhydroxides) under these conditions, lowering the concentration of free metal ions in the solution. For this reason, auxiliary complexing agents or ligands such as ammonia, tartrate, citrate, or triethanolamine are used in EDTA titrations to...
694
Acid–Base Titration: Overview01:26

Acid–Base Titration: Overview

An acid-base titration is a technique used to determine the concentration of an unknown acid or base, using a titrant of known concentration–either a base for acid titration or an acid for base titration. The process involves gradually adding the titrant, leading to a predictable change in the pH of the solution. This change is plotted on a titration curve, showing how a solution's pH varies with the amount of titrant added. Such curves are instrumental in monitoring the...
11.5K
Titration of Polyprotic Acids with a Strong Base01:23

Titration of Polyprotic Acids with a Strong Base

Titration of a polyprotic acid, which contains multiple ionizable protons, involves distinct dissociation steps, each with its own dissociation constant (Ka). Each successive Ka is weaker than the previous one. In the titration of a polyprotic acid like sulfurous acid with a strong base such as sodium hydroxide, the base first neutralizes the initial ionizable proton, forming an intermediate species (e.g., hydrogen sulfite ions). This step's titration curve resembles that of a weak...
1.9K
Titration of a Polyprotic Acid02:08

Titration of a Polyprotic Acid

A polyprotic acid contains more than one ionizable hydrogen and undergoes a stepwise ionization process.  If the acid dissociation constants of the ionizable protons differ sufficiently from each other, then the titration curve for such polyprotic acid generates a distinct equivalence point for each of its ionizable hydrogens. Therefore, titration of a diprotic acid results in the formation of two equivalence points, whereas the titration of a triprotic acid results in the formation of three...
97.3K
Complexometric EDTA Titration Curves01:20

Complexometric EDTA Titration Curves

EDTA titration curves determine the free metal ion concentration. The titration curve represents the change in concentration of free metal ions (p function) as a function of the volume of EDTA added. This curve consists of three regions: before, at, and after equivalence points. Excess free metal ions are present before the equivalence point. Equal concentrations of metal ions and EDTA are present at the equivalence point. After the equivalence point, excess EDTA exists. This means slight...
1.1K
Titration of a Strong Acid with a Strong Base01:23

Titration of a Strong Acid with a Strong Base

During the titration of a strong acid with a strong base, pH calculations are primarily based on the concentration of residual hydronium or hydroxide ions. Initially, a strong acid like hydrochloric acid fully dissociates, creating hydronium and chloride ions, resulting in a low pH. The addition of a strong base like sodium hydroxide alters the concentration of hydronium ions by neutralizing them. As more base is added, the pH gradually increases. At the equivalence point, all hydronium ions...
6.4K