Jove
Visualize
Contact Us
JoVE
x logofacebook logolinkedin logoyoutube logo
ABOUT JoVE
OverviewLeadershipBlogJoVE Help Center
AUTHORS
Publishing ProcessEditorial BoardScope & PoliciesPeer ReviewFAQSubmit
LIBRARIANS
TestimonialsSubscriptionsAccessResourcesLibrary Advisory BoardFAQ
RESEARCH
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchive
EDUCATION
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualFaculty Resource CenterFaculty Site
Terms & Conditions of Use
Privacy Policy
Policies

Related Concept Videos

Cardiopulmonary Resuscitation II: ACLS Airway Management01:22

Cardiopulmonary Resuscitation II: ACLS Airway Management

129
Airway management is a key skill in emergency and critical care settings, as maintaining a clear airway is essential for adequate oxygenation and ventilation.Head Tilt-Chin Lift TechniqueThe head tilt-chin lift maneuver is an essential technique primarily used in patients without suspected cervical spine injuries. To perform this maneuver, one hand is placed on the patient’s forehead, and gentle pressure is applied backward to tilt the head. The fingertips of the other hand are positioned...
129
Mechanical Ventilation II: Invasive Ventilation01:23

Mechanical Ventilation II: Invasive Ventilation

286
Ventilators are essential medical equipment used to aid patients with respiratory difficulties. Their primary function is to assist or replace spontaneous breathing by providing mechanical ventilation. There are two general classes of mechanical ventilators: negative-pressure and positive-pressure ventilators.
Negative-Pressure Ventilators
Negative-pressure ventilators create a vacuum around the chest or body to draw air into the lungs, simulating breathing. This method does not require an...
286
Ventilatory Modes01:14

Ventilatory Modes

499
Mechanical ventilators are life-saving devices that support or replace spontaneous breathing. They deliver breaths to patients through varying methods known as ventilator modes. Understanding these modes is critical for healthcare providers managing patients with respiratory failure.
There are three ventilatory modes: full support, partial support, and spontaneous. These are described below.
Full Support Modes
Full support modes include controlled mechanical ventilation, continuous mandatory...
499
Administering Oxygen by Mask01:30

Administering Oxygen by Mask

814
Administering Oxygen by Mask
Administering oxygen by mask is a common nursing intervention that provides supplemental oxygen to patients with respiratory distress or chronic lung conditions. This procedure involves delivering oxygen at a specified rate through a face mask connected to an oxygen source.
Equipment
The equipment necessary for this procedure includes:
814
Mechanical Ventilation III: Noninvasive Ventilation01:23

Mechanical Ventilation III: Noninvasive Ventilation

263
Noninvasive positive-pressure ventilation (NIPPV), continuous positive airway pressure (CPAP), and bilevel positive airway pressure (BiPAP) are essential methods in respiratory care. These ventilation techniques offer unique benefits for patients with various respiratory conditions, providing adequate support without requiring intubation. Let's explore how each method is crucial in improving patient outcomes and enhancing respiratory therapy.
Noninvasive Positive-Pressure Ventilation...
263
Oxygen Delivering System I: Nasal Cannula and Face Mask01:26

Oxygen Delivering System I: Nasal Cannula and Face Mask

651
The human body requires oxygen to function, and when the natural process of respiration is hindered, external devices, including the following, are needed to help deliver this vital gas.
Nasal Cannula
A nasal cannula is a lightweight tube split at one end into two prongs and placed in the nostrils. It is typically used to deliver low to medium levels of oxygen.
Suggested flow rate: The suggested flow rate for a nasal cannula typically ranges between 1 and 6 L/min.
Oxygen percentage setting:...
651

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by
Same author

Long-term survival in patients discharged alive from hospital following an intensive care unit admission with sepsis or septic shock in Australia and New Zealand: an observational cohort study.

The Lancet regional health. Western Pacific·2026
Same author

AI-Assisted Chest X-Ray Interpretation in Resource-Limited Settings: LuAna Stepped-Wedge Trial Protocol.

JMIR research protocols·2026
Same author

Characteristics and outcomes of intensive care patients receiving metaraminol infusion-a retrospective observational cohort study.

Anaesthesia and intensive care·2026
Same author

Characteristics, management, and outcomes of segmental and subsegmental pulmonary embolism in ICU patients: A retrospective cohort study.

PloS one·2026
Same author

Association of clinical characteristics to mortality in acute respiratory failure patients treated with ECCO<sub>2</sub>R.

The International journal of artificial organs·2026
Same author

Beyond equipoise: why automated ventilation trials should measure what really matters.

Critical care science·2026

Related Experiment Video

Updated: Sep 22, 2025

Evaluating Regional Pulmonary Deposition using Patient-Specific 3D Printed Lung Models
07:56

Evaluating Regional Pulmonary Deposition using Patient-Specific 3D Printed Lung Models

Published on: November 11, 2020

4.4K

Automation to improve lung protection

Laura A Buiteman-Kruizinga1,2, Ary Serpa Neto3,4,5,6,7, Marcus J Schultz3,8,9,10

  • 1Department of Intensive Care, Reinier de Graaf Hospital, Reinier de Graafweg 5, 2625 AD, Delft, The Netherlands. l.kruizinga@rdgg.nl.

Intensive Care Medicine
|May 20, 2022
PubMed
Summary

No abstract available in PubMed .

More Related Videos

Procedure for Lung Engineering
12:50

Procedure for Lung Engineering

Published on: March 8, 2011

46.8K
Design and Implementation of a Rat Ex Vivo Lung Perfusion Model
04:38

Design and Implementation of a Rat Ex Vivo Lung Perfusion Model

Published on: May 26, 2023

925

Related Experiment Videos

Last Updated: Sep 22, 2025

Evaluating Regional Pulmonary Deposition using Patient-Specific 3D Printed Lung Models
07:56

Evaluating Regional Pulmonary Deposition using Patient-Specific 3D Printed Lung Models

Published on: November 11, 2020

4.4K
Procedure for Lung Engineering
12:50

Procedure for Lung Engineering

Published on: March 8, 2011

46.8K
Design and Implementation of a Rat Ex Vivo Lung Perfusion Model
04:38

Design and Implementation of a Rat Ex Vivo Lung Perfusion Model

Published on: May 26, 2023

925