Effects of voltage and pressure on sludge electro-dewatering process and the dewatering mechanisms investigation

Electro-dewatering technology shows a good application prospect because of its high efficiency in removing water from sludge and low energy consumption, but the potential mechanisms of sludge electro-dewatering have not been investigated in depth, which seriously limits the further development and application of electro-dewatering technology. In this study, the effects of voltage and pressure on sludge electro-dewatering performance, physicochemical characteristics and extracellular polymeric substances (EPS) compositions and distributions were investigated. The spatial distributions of EPS main components, including polysaccharide (PS) and protein (PN), were characterized by a confocal laser scanning microscopy (CLSM). The experimental results showed that under the conditions of a voltage of 40 V and a pressure of 90 kPa, the moisture content of sludge was reduced from 83.15% to 53.12%, and the bound water content of sludge in the anode layer, middle layer and cathode layer were decreased significantly from 1.16 g/g dry solid (DS) to 0.20, 0.47 and 0.35 g/g DS, respectively. The PN content of EPS in anode layer was significantly lower than that in cathode layer due to the electrochemical oxidation, while the variation of PS content showed the opposite trend, which agreed with the results visualized by CLSM. Pearson's correlation coefficient and hierarchical cluster analysis revealed that PN in TB-EPS was the major factor influencing the effect of sludge electro-dewatering. This work can be helpful to understand the potential mechanisms of electro-dewatering and provide theoretical support for the further popularization and application of electro-dewatering technology.