The Cause of Ribbon Fluctuation in Magnetorheological Finishing and Its Influence on Surface Mid-Spatial Frequency...

In the high-power laser system, the mid-spatial frequency error of the surface of the high-power laser component will affect the normal operation of the high-power laser system. In order to improve the mid-spatial frequency error of the high-power laser component after magnetorheological finishing, the causes and influencing factors of the ribbon fluctuation in magnetorheological finishing are studied, and the influence of different ribbon fluctuation on the mid-spatial frequency error of the surface is studied. Firstly, the influence of different ribbon fluctuations on the mid-spatial frequency error of the machined surface is simulated by a computer. Secondly, the magnetic field in the circumferential direction of the polishing wheel, the fluctuation amount and frequency of the magnetorheological polishing ribbon are measured, and then the causes of the fluctuation of the magnetorheological polishing ribbon are analyzed. Moreover, through the principle of a single variable, the influence of process parameters on the fluctuation of magnetorheological polishing ribbon is explored. Finally, the fused silica component is scanned uniformly under the process parameters of magnetorheological polishing ribbon fluctuation of 40 μm, 80 μm, 150 μm, and 200 μm. The experimental results show that the greater the ribbon fluctuation, the greater the surface mid-spatial frequency error of the component, and the ribbon fluctuation is approximately linear with the RMS of the PSD2 in the mid-spatial frequency band on the surface of the component. Therefore, the fluctuation of the ribbon can be controlled by controlling the magnetorheological processing parameters, and the mid-spatial frequency band error on the surface of the high-power laser component can be significantly reduced by optimizing process parameters after magnetorheological finishing.