Effect of Reinforcements and 3-D Printing Parameters on the Microstructure and Mechanical Properties of Acrylonitrile...

Fused filament fabrication (FFF) systems utilize a wide variety of commercially available filaments, including Acrylonitrile Butadiene Styrene (ABS), as well as their variants. However, the effect of filament composition, reinforcements (chopped fibers and nanotubes), and 3-D printing variables on the microstructure and thermomechanical behavior is not well understood, and systematic studies are needed. In this work, different types of ABS materials with and without carbon fiber and carbon nanotube reinforcements were printed with multiple print layer heights. The microstructure, elastic behavior, tensile behavior, and fracture toughness of 3-D printed materials were characterized. ABS material systems printed at a low print layer height of 0.1 mm outperformed those printed at a larger height of 0.2 mm. Carbon nanotube reinforcements result in significant improvement in the strength and elastic modulus of ABS materials. Printed coupons of ABS with carbon nanotubes achieve an ultimate strength of 34.18 MPa, while a premium grade ABS coupon achieved 28.75 MPa when printed with the same print layer heights. Samples of ABS with chopped carbon fiber show an ultimate strength of 27.25 MPa, due primarily to the significant porosity present in the filament. Elastic moduli and fracture toughness measured using dynamic and mechanical methods show similar trends as a function of layer height. The effects of different materials, reinforcements, and printing parameters on the microstructure and mechanical properties are discussed in detail.