Changes in biceps brachii muscle hardness assessed by a push-in meter and strain elastography after eccentric versus

Mitsuyoshi Murayama1, Takayuki Inami2, Norihiro Shima3

  • 1Institute of Physical Education, Keio University, Address 4-1-1, Hiyoshi, Kouhoku-ku, Yokohama, 223-8521, Japan. murayama@keio.jp.

Scientific Reports
|June 2, 2022
PubMed

Related Concept Videos

Isotonic and Isometric Muscle Contractions01:22

Isotonic and Isometric Muscle Contractions

Two primary types of muscle contractions are isotonic and isometric, each serving unique functions and involving distinct mechanisms. Both isotonic and isometric contractions are integral to the body's complex system of movement and stability. Isotonic exercises contribute significantly to functional strength and movement, while isometric contractions are crucial for maintaining posture and joint stability.
Isotonic contractions
Isotonic contractions occur when a muscle changes length while...
4.2K
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
274
Strain and Elastic Modulus01:15

Strain and Elastic Modulus

The quantity that describes the deformation of a body under stress is known as strain. Strain is given as a fractional change in either length, volume, or geometry under tensile, volume (also known as bulk), or shear stress, respectively, and is a dimensionless quantity. The strain experienced by a body under tensile or compressive stress is called tensile or compressive strain, respectively. In contrast, the strain experienced under bulk stress and shear stress is known as volume and shear...
4.1K
Elasticity in Concrete01:20

Elasticity in Concrete

Upon subjecting concrete to moderate or high uniaxial compressive or tensile stresses, the strain response is non-linear relative to the stress applied. As the stress is removed, the resulting stress-strain curve deviates from the original path traced during loading, creating a hysteresis loop, indicative of the concrete's non-linear and non-elastic properties. Typically, a material's modulus of elasticity, which is a measure of the material's stiffness, is inferred from the linear...
157
Hooke's Law01:26

Hooke's Law

Hooke's law, a pivotal principle in material science, establishes that the strain a material undergoes is directly proportional to the applied stress, defined by a factor called the modulus of elasticity or Young's modulus.
582