Related Experiment Video
Updated: Sep 21, 2025

A Fabrication and Measurement Method for a Flexible Ferroelectric Element Based on Van Der Waals Heteroepitaxy
Published on: April 8, 2018
Optically Encodable and Erasable Multilevel Nonvolatile Flexible Memory Device Based on Metal-Organic Frameworks
Mujahid Mustaqeem1,2,3, Jia-Yu Lin2, Saqib Kamal4
1Department of Chemistry, National Taiwan University, No. 1, Section 4, Roosevelt Road, Taipei 10617, Taiwan.
Abstract:
Multilevel and flexible nonvolatile memory (NVM) is a promising candidate for data storage in next-generation devices but its high bias and low mobility of conducting channels are often its drawbacks. In this study, we demonstrate a low bias of smaller than 0.1 V and a high-mobility graphene layer as a conducting channel for flexible optoelectronic NVM based on a composite thin film of indium-based MOF-derived InCl3 and 4,4-oxydiphthalic anhydride (odpta), Na[In3(odpt)2(OH)2(H2O)2](H2O)4, and reduced graphene oxide (rGO). The optoelectronic NVM device can be encoded and erased optically by ultraviolet (UV) light and visible light, respectively. Our device also achieves memory states over 192 (6-bit storage) distinct levels, which can emerge as mass data storage. It also shows an excellent endurance of write-erase cycles under irradiation with a laser of varying wavelengths, the mechanical stability of more than 1000 bending cycles, and stable retention for longer than 10 000 s. These results open an alternative route for developing low bias and innovative optoelectronic technologies.
More Related Videos
Related Concept Videos
MOS Capacitor
The metal gate is typically made from highly conductive materials such as aluminum or polysilicon. Beneath the metal gate lies a thin layer of...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...

