Covalent grafting diazotized black phosphorus with ferrocene oligomer towards smoke suppression and toxicity...

In comparison with the thermal hazard of polymers, noxious smoke and gas produced by the combustion of polymers make the environment self-purification a huge challenge. As a new type of a highly effective flame retardant, black phosphorus (BP) can effectively decrease the thermal hazard of polymers, but its performances in smoke suppression and toxicity reduction are unsatisfactory. In this article, a method of covalently grafting diazotized BP with a ferrocene oligomer was applied to promote the smoke suppression and toxicity reduction efficiency of BP. In our work, the BP-NH nanomaterials with a mass of amino groups on the surface were acquired by diazotizing the BP. Then, the BP-Fe was obtained by covalently grafting the ferrocene chloride salt and nitrogen-containing heterocycles on the surface of BP. The smoke production rate (SPR) and total smoke production (TSP) values of the epoxy resin (EP) decreased by 49.8% and 52.5% with the addition of 2 wt% BP-Fe, respectively. In comparison with previous studies, this work was far more effective than the previous work in smoke suppression and flame retardant. The release of toxic gases (CO and HCN) and volatile organic compounds in the EP was also effectively inhibited at the same time. In addition, the storage modulus and tensile strength of nanocomposites increased by 35.1% and 27.2% with the addition of 1 wt% BP-Fe. This work also provides a new idea on how to simultaneously strengthen the toxic smoke suppression, mechanical properties, and flame retardant of polymer materials.