Preparation and mechanical properties analysis of porous structure for bone tissue engineering

With the increasing aging of population, the incidence rate of diseases such as fracture and osteoporosis has been increasing. The demand for implant in Department of orthopedics has increased. The elastic modulus of the existing solid metal implant is much higher than that of human bone tissue, and it is easy to produce stress shielding effect after operation, which causes complications such as loosening of prosthesis and low fusion efficiency.

In order to solve the mismatch of elastic modulus between solid metal orthopedic implants and human bone tissue, metal structures with excellent mechanical properties were prepared.

The porous structure was designed by spatial dot matrix method, and the metal porous structure was prepared based on selective laser melting 3D printing technology. The residual stress in the preparation process was eliminated by vacuum annealing heat treatment, and the static compression experiment was carried out to study the effects of different pore shape and porosity parameters on the compressive yield strength and elastic modulus of porous structure. The performance changes of porous structure before and after heat treatment were compared, and the porous structure meeting the performance requirements of human bone tissue was selected.

The porous structure prepared by selective laser melting technology met the requirements of human bone tissue. The elastic modulus was as low as 0.74 GPa and the compressive yield strength is 201.91 MPa; After annealing heat treatment, the compressive yield strength of porous structure decreased, the maximum change was 3.69%, the elastic modulus increased, and the maximum change was 8.69%.

For the porous structure with the same pore shape, the lower the porosity, the better the mechanical properties of the porous structure. For the same porosity, the comprehensive mechanical properties of dodecahedral porous structure were the best and octahedral porous structure was the worst; the porous structure after annealing heat treatment was more conducive to meet the performance requirements of human bone tissue.