[Investigation and analysis of occupational hazards in construction of power transmission and transformation project]

Objective: To investigate the occupational hazard factors and exposure levels of workers during the construction of power transmission and transformation projects. Methods: Analysis and identification of occupational hazard factors were carried out for typical construction process of 6 power transmission projects and 3 substation projects in September 2018. The on-site occupational health investigation was carried out to detect and analyze the exposure levels of workers to occupational hazard factors. Results: The time weighted average concentration (C(TWA)) of crushing workers exposed to silica dust and welders exposed to welding fume in substation projects were 2.72 and 14.03 mg/m(3), respectively. The 8 h equivalent sound level results of exposure noise of carpenters in power transmission projects and crushing workers, reinforcement workers, carpenters, scaffolders, road builders in substation projects were 87.9, 92.5, 87.1, 92.5, 93.0 and 90.2 dB (A) , respectively. The 4-hour time equal energy frequency weighted vibration acceleration of hand-transmitted vibration of bricklayer in power transmission projects, bricklayer, general worker 3, road builder 1 and road builder 2 of substation projects were 5.36, 5.21, 5.28, 10.71 and 5.22 m/s(2), respectively. The effective irradiance of electric welding arc light of welders' limbs in power transmission projects and substation projects were 401.19, 319.68 μW/cm(2), respectively. All of the above exceeded the requirements of occupational exposure limits. The occupational radiation levels and exposure limits of hazardous chemical factors met the requirements of each post. Conclusion: During the construction of power transmission and transformation projects, the exposure levels of occupational hazard factors in multiple posts exceed the standard. The main responsibility of employers for occupational disease prevention and control should be implemented, and targeted comprehensive measures should be taken to reduce the exposure levels of occupational hazard factors of workers.