[Role of personalized 3D printing in brain protection after decompressive craniectomy]

Objective: To explore the application value of personalized three-dimensional (3D) printed protective cap in brain protection after decompressive craniectomy (DC). Methods: Fourty-five patients who underwent DC from January 2021 to October 2021 were selected, including 26 males and 19 females, aged 5-73 (50±13) years old. The brain CT data were imported into 3D Slicer software to rebuild the protective cap through 3D printing. The cap was worn on the head of the patient, thereby preventing secondary braindamage. The follow-up results were compared with 53 patients without protective capduring the same period. Results: There were no statistically significant differences in age, skull defect location and follow-up time between the two groups (all P>0.05).Among 45 patients, 47 brain protective caps (2 cases with bilateral skull defects) were successfully designed. The time for image post-processingand 3D printing was (21.2±6.0) min and (62.4±8.3) min, respectively. There were 6 cases of low compliance, 9 cases of moderate compliance, 32 cases of high compliance, respectively. Six cases with low conformity were redesigned and printed, 2 of 9 cases with moderate conformity were redesigned and printed, and the remaining 7 cases reached high compliance after grinding and packaging. In the current study, 45 patients with brain protective caps were followed up for 3 months, and no secondary brain injury occurred. However, among 53 patients without brain protective caps during the same period, 4 patients had secondary accidental brain compression. The incidence of injury was 7.5 %, and the difference was statistically significant (P<0.001). Conclusion: Brain protective cap designed based on cranial CT and 3D printing can be used in patients with skull defects to protect the brain tissue from secondary crush damage and has certain clinical value.