The Role of Diffusion Tensor Tractography in Assessment of Spondylotic Myelopathy

Introduction Cervical spondylotic myelopathy (CSM) describes a neurological deficit related to the spinal cord due to the changes in the facet joints and discs of the cervical spine as a result of degeneration. Diagnosis is mainly dependent on imaging. Diffusion tensor tractography (DTT), being a non-invasive technique, shows better sensitivity when compared to the conventional T2WI sequence in the early detection of cervical spondylotic myelopathy (CSM). The objective was to determine the diagnostic accuracy of the apparent diffusion coefficient (ADC) in predicting high T2 signals in CSM. Methods A prospective observational study was done on 47 subjects aged between 25 and 70 years, referred to the department of radiology with clinical and imaging evidence of CSM in a tertiary care institute in Chennai. Nurick classification system was used to assess severity clinically. Diffusion-weighted imaging and DTT were done with 1.5 Tesla MRI. The primary outcome variable was a high T2 signal. Mean fractional anisotropy (FA) at the stenotic level and ADC value at a stenotic level were considered explanatory variables. The sensitivity, specificity, predictive values, and diagnostic accuracy of the screening test with the decided cut-off values along with their 95% CI were presented. P-value <0.05 was considered statistically significant. SPSS version 22 (IBM Inc., Armonk, New York) was used for statistical analysis. Results The mean age was 48.26 ± 10.28 years. The majority (72.34%) were males, the majority (42.55%) had a Nurick score of two, and 25.53% had a Nurick score of one. Twenty-six (55.32%) reported a high T2 signal, 36 (76.60%) had elevated ADC, and 11 (23.40 %) had no elevated ADC. There was a statistically significant difference in mean FA and ADC values across groups categorized as non-stenotic level and stenotic level (p-value <0.05). The ADC value had a moderately high sensitivity (76.92%) and low specificity (23.81%) in predicting high T2 signals with a diagnostic accuracy of 53.19%. Conclusion DTI parameters at stenotic level (ADC and FA values) in patients with cervical spondylosis help in the early detection of cervical cord compressive myelopathy prior to the appearance of T2 signal changes in conventional MRI, thereby improving clinical outcome and patient management.