Porous {P6Mo18O73}-type Poly(oxometalate) Metal-Organic Frameworks for Improved Pseudocapacitance and Electrochemical
Tingting Zhao1, Li-Ping Cui2, Kai Yu1,3
1Key Laboratory for Photonic and Electronic Bandgap Materials, Ministry of Education, School of Chemistry and Chemical Engineering, Harbin Normal University, Harbin 150025, P. R. China.
Abstract:
{P6Mo18} poly(oxometalate) (POM) clusters have huge steric hindrance and limited active oxygen atoms, which make them difficult to combine with metal-organic units to form three-dimensional (3D) porous structures. Therefore, functionalization of such POMs has always been a bottleneck that is difficult to break through. In this study, {P6Mo18} POM was successfully grafted on a lock-like metal-organic chain to generate a multiporous coordination polymer, [{Na(H2O)(H2btb)}{Cu4I(H2O)(pz)5Cl}{H2Sr⊂P6Mo2VMo16VIO73}]·3H2O (1) (pz = pyrazine; btb = 1,4-bis(1,2,4-triazole) butane). Meanwhile, a zero-dimensional (0-D) control compound with only btb ligands as counterions, (H4btb)[H4Sr⊂P6Mo2VMo16VIO73]·3H2O (2), was also obtained via a hydrothermal reaction. Compound 1 represents the first basket-type 3D poly(oxometalate) metal-organic framework (POMOF) assembly, which possesses interpenetrating pores and complex topology. 1-GO-CPE displays improved supercapacitor (SC) performance (the specific capacitance of 929.4 F g-1 at a current density of 3 A g-1 with 94.1% of cycle efficiency after 5000 cycles) compared with 2-GO-CPE and most reported POMOF electrode materials, which may be due to the outstanding redox capability of basket-POM, introduction of metal-organic chains, intersecting pores, and excellent conductivity of graphene. An asymmetric SC device with 1-GO-CPE as the negative electrode exhibits an energy density of 29.7 Wh kg-1 with a power density of 3148.2 W kg-1 and long-lasting cycling life. In addition, 1-GO-GCE as an electrochemical sensor responds to dopamine (DA) at a voltage of 0.40 V and shows lower detection limits (0.19 μM (signal-to-noise ratio (SNR) = 3)), higher selectivity, and good reproducibility in the linear range of 0.56 μM to 0.24 mM. The ability to accurately detect the content of DA in biological samples further proves the feasibility of the sensor in practical applications.
More Related Videos
05:47Preparation of Polyoxometalate-based Photo-responsive Membranes for the Photo-activation of Manganese Oxide Catalysts
Published on: August 7, 2018
10:27Preparation of Highly Porous Coordination Polymer Coatings on Macroporous Polymer Monoliths for Enhanced Enrichment of Phosphopeptides
Published on: July 14, 2015
Related Concept Videos
MOS Capacitor
The metal gate is typically made from highly conductive materials such as aluminum or polysilicon. Beneath the metal gate lies a thin layer of...
Potentiometry: Membrane Electrodes
