Related Experiment Video
Updated: Sep 6, 2025
Analysis of Craniomaxillofacial Malformations in Mice Using Three-dimensional Microcomputed Tomography
Published on: January 17, 2025
Fetal facial bone growth: Post-mortem CT analysis
E Lesieur1, C Delteil2, G Gorincour3
1Screening and Diagnosis Unit, department of Obstetrics and Gynecology, Timone Hospital, Marseille, France; UMR 7268 ADES Anthropologie droit éthique et santé, Aix Marseille université, CNRS, EFS, Marseille, France.
Objective:
To describe and model the normal growth of fetal facial bones and angles.
Material And Methods:
A total of 118 fetal CT scans obtained at 19 to 41 weeks gestation after in utero fetal death or late miscarriage were analyzed. CT scan was followed by autopsy and pathological examination and only fetuses free from brain disease or abnormal craniofacial development were included. The measurements were taken using software for frontal, sagittal and 3D reconstruction from native axial sections. The optimal plane for bone analysis was chosen and the measurements made by multiplanar reconstruction.
Results:
There was a statistically significant increase (P<0.001) in all measurements regardless of gestational age (GA) except those of the mandibulo-fronto-maxillary angle (P=0.412), the naso-mandibulo-maxillary angle (P=0.828) and mandibular width (P=0.86). There was no significant difference according to fetal sex. Based on these results, the corresponding growth curves were created. The anteroposterior mandibular diameter (APD) was very strongly correlated with GA (R=0.926, P<0.001). The following equation: GA=(8.187×APD)+4.257 can be used to estimate GA with a confidence interval (CI) of±2.42. The same applies to maxillary width (MW) (R=0.922; P<0.001). The equation GA=(11.059×MW)+7.571 can be used to estimate GA with a CI of 2.17.
Conclusion:
The growth of the mandible, maxilla, zygomatic bone and orbits was measured and the corresponding growth curves were established. Several measurements were strongly correlated with gestational age.
More Related Videos
Related Concept Videos
01:29Bone Formation by Intramembranous Ossification
The process begins when mesenchymal cells in the embryonic skeleton gather together and differentiate into osteogenic cells, which then develop into ...
01:22Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...
01:14Cranial Bones: Superior and Posterior View
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
01:09Changes in the Appendicular Skeleton with Age
Initially, the limb buds consist of a core of mesenchyme covered by a layer of ectoderm. The ectoderm at the end of the limb bud thickens to form a narrow crest called the apical ectodermal ridge. This ridge stimulates the underlying...