Study on Wear Mechanism of Helical Gear by Three-Body Abrasive Based on Impact Load

This study aimed to explore the wear characteristics and evolution mechanisms of large-scale wind power gears under the impact load of particles of the three-body abrasive Al2O3 (0.2 mg/mL) from four aspects: oil analysis, vibration analysis, amount of gear wear, and tooth-surface-wear profile analysis. A magnetic powder brake was used to simulate the actual working conditions. Combined with the abrasive particle monitoring and the morphology analysis of the tooth-surface-wear scar, by setting quantitative hard particles in the lubricating oil, the gears are mainly operated in the abrasive wear state, and wear monitoring and wear degree analysis are carried out for the whole life cycle of the gears. Oil samples were observed and qualitatively analyzed using a particle counter, a single ferrograph, a metallographic microscope, and a scanning electron microscope. The experiments demonstrate that the initial hard particles have a greater impact in the early wear stage of the gears (<20 h), and abrasive particle concentration increases by 30%. This means that Al2O3 particles accelerate the gear wear during the running-in period. The loading method of the impact load on the oblique gear exacerbates the abrasion particle wear and expands the stress concentration, which reduces the surface of large milling particles on the surface, and reduces the width of the tooth (the part above the pitch line is severely worn), which causes the gear to break into failure. The research provides help for analyzing the mechanism of abrasive wear of gears and predicting wear life.